aditec MIC 3000 - Program Start and Operation; Program Start

User Manual MIC 900 / MIC 1100 / MIC 3000
28
Issue 17.08.2021_00
4.6.1 Enabling VisuNet
When you want to set up or edit programs you need the COMFORT version of VisuNet. The controller
has to be enabled for this service. For further information contact your installation manufacturer or
aditec.
4.6.2 Editing programs with VisuNet
For how to edit programs with VisuNet please see the user manual „VisuNet Base / Comfort /
Premium“ – Chapter 5 „Entering, changing, copying and starting programs“.
5 Program start
After you have selected a program as described under „Selecting a program“, item 2.2, page 13, you
can start the program. At least one program step has to be pre-programmed.
Start settings
Be aware
If administrators have been assigned in the controller, a password will be required
before a program can be started. Only users with the authority to start a program,
can do so.
5.1.1 Instant start
With „Instant start “ the installation will immediately start operating.
5.1.2 Start with time of day
Press the date or the time box and enter the desired start time and the start date. Then confirm with
„Enter“.
If the entered start date and time have already passed, the controller will start immediately. If the
entered start date and time are in the future, the waiting time interval will start. On the info bar you can
see the pre-set start time and the „Stop“ button is flashing. Once the start time arrives, the program will
start and the display on the info bar will change to „Installation in operation“.
Press the „Exit“ to cancel the start sequence and return to standby.
Please note
While the waiting time is running the „Stop“ button on the task bar will be flashing. If you press
the „Stop“ button, waiting mode will be terminated and the controller will return to standby
mode.