aditec MIC 3000 - Copying Programs Onto a USB; Saving Data Logger Data Onto a USB; Show Versions

User Manual MIC 900 / MIC 1100 / MIC 3000
41
Issue 17.08.2021_00
8.5.2 Copying programs onto a USB
The controller saves all programs onto a USB under \ProgUSB\Program.adp.
The programs can then be read by another MIC900 device.
Administrator rights
This setting is protected by a PIN when administrators are registered. Only users with the
authority to „Set up programs“ have access to this feature.
8.5.3 Saving data logger data onto a USB
The data of programs that have already run are saved onto a USB. The data can then be imported
into VisuNet (see manual VisuNet 6.1.4 Wireless data transfer).
Hint
Copying data onto a USB mass storage can take several minutes, please do not remove
the USB stick or SD card during this process until you get a message to do so.
Be aware
After the data has been successfully copied, it is deleted from the SD card.
8.6 Show versions
The version number, device number, IP number, port, MAC address, VisuNet if enabled and the
current system temperature are shown here.
Please note
Please include the device number and the version number with the date if you send us an
enquiry!
Versions