User Manual MIC 900 / MIC 1100 / MIC 3000
2.5 Program run times
Press the symbol to show the program runtime or the remaining program runtime.
Program runtime: Duration of the current program
(including all steps)
Remaining program runtime: Time that remains
until the program ends (including all steps). Only the
steps that have a pre-programmed step time are
taken into account.
Time paused
The time count is paused, the colon between the
minute and second (00:05) display is not flashing.
The display is shown in red.
The remaining program runtime is also calculated if steps without step time have been pre-
programmed. When a step without step time is in operation, the remaining program runtime
cannot be counted backwards. During these steps the colon in the remaining program
runtime display will not be flashing.
2.6 Optional displays
Depending on the configuration settings, different optional displays are available for the various
values. In some cases, settings can be changed via these displays.
Use the arrow button to browse through the enabled displays.
Browsing through
the optional displays
2.6.1 Optional nominal values
If additional nominal values (e.g. FC value, Delta temperature, air
circulation) or aggregate buttons have been enabled, they are all
shown on the „Optional nominal value“ list.
Press the current nominal value to change it during operation.
(Changeover ON/OFF or changing the values via the numerical
pad)
If the intelligent air circulation is programmed the active level
appears in green colour.
The new nominal values are only valid in the current step. They are not saved and are
only valid until the end of the step. If you want to make permanent changes to the
nominal values you need to go to „Programming mode“, item 4, page 21 and make the
changes there.
To Next Page
Loading...
