aditec MIC 3000 - Power Failure

User Manual MIC 900 / MIC 1100 / MIC 3000
46
Issue 17.08.2021_00
• Screensaver: aktivate/deactivate
• Screensaver selection: what should be displayed when the screensaver is activated
OFF
Analogue clock with date
Digital clock
Black screen
• Waiting time: Time after which the screen saver displayed if no input is made.
Be aware
When an alarm happens, the screensaver is closed and remains inactive until the alarm is
cancelled.
 Factory setting
1
:
Screensaver: on
Screensaver selection: Analogue clock
Waiting time: 5 min
9 Power failure
If a program, which is currently in operation, is interrupted due to a power failure or because the
device is switched off, the controller will resume the program as soon as power is restored
Be aware
The behaviour of the device in case of a power failure (depending on a pre-set
temperature difference, „always“or „never“) can be configured by your service engineer
under configuration/various settings!
1
Settings are loaded only during the total deletion. When executing the code 9993, the settings are not changed.
Hint
When the screen saver is activated, it can be previewed by pressing the F5 "Test" key.