Hybrid Standalone NVR User Guide 4 Web Service
Figure 4-63
Tour
Enable the tour function to present an alternating display (much like a slideshow) of the channel(s)
you have set to record when a motion detect event occurs. The system supports 1/8-window tour.
Refer to Tour Tab on page 202 for tour interval setup. However, the alarm tour has higher priority
than the tour setup you set in the Display screen.
Snapshot
When an alarm occurs, this feature takes a still image of the channel(s) you set to record. Check the
box to enable, and then click the buttons for the channels that you want included in the snapshot.
The selected channels are highlighted.
Checkboxes
Show Message. If enabled, a pop up alarm message appears in the local host screen.
Send Email. If enabled, an email alert is sent to you when an alarm occurs.
Buzzer. If enabled, a buzzer sounds when an alarm occurs.
Message. If a 3G network is connected, a message is sent when an alarm occurs.
Note: This feature is not supported by ADT at this time.
NVR4200 Series User Guide
182
To Next Page
Loading...
Need help?
General