Adtech CNC9640 User Manual

ADTECH9 Series CNC Maintenance Manual
- 115 -
Effective time : Restart
Note : The ID number setting of the controller when DNC or other PC
software and this controller are in MODBUS communication mode
014 Circle Inp Unit(mm)
Range : 0~1
Unit : mm
Authority : Operation admin or higher
Default : 0.2
Effective time : Instant
Note : Set the arc interpolation equivalent
If this value is too small, the arc has higher approximation accuracy, but
the computation will be too high, making the pause during processing
obvious and affecting the processing effect.
015 G73(M) Loop Obligate(mm)
016 G83(M) Loop Obligate(mm)
Range : 0.1~100
Unit : mm
Authority : Operation admin or higher
Default : 2.000
Effective time : Instant
Note : Set the tool retracting amount after Q is fed in G73 and G83
instructions; this parameter (default: 2mm) is set according to actual
chip removal effect.
017 Arc interpolation processing mode
Range : Time split, position split
Unit : None
Authority : Operation admin or higher
Default : Position split
Effective time : Instant
Note : Position split is done based on arc length
Time split is done by time.
018 Speed optimization constraint mode
Range : Angle Speed Speed1

Adtech CNC9640 Specifications

General

Brand	Adtech
Model	CNC9640
Category	Control Systems
Language	English