Adtech CNC9640 User Manual

ADTECH9 Series CNC Maintenance Manual
- 117 -
Range : 0~1
Unit : None
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note : Control mode corresponding to spindle S code (frequency conversion
mode)
0 : Analog output
1: Section speed regulation (4-digit code determined by output port
configured by spindle parameters P6.014 ~ P4.017), as below:
P6.014------S0
P4.015------S1
P4.016------S2
P4.017------S3
In analog output mode, the analog voltage is:
V＝S/MaxRPM
S is the rotation set by the user, and MaxRPM is the maximum rotation
of spindle set by the parameter (P4.017);
In switching quantity mode, constitute block 0-15 according to
four-digit code to output; S code value is restricted to 0-15;
022 Lubricant Pressure Open(min)
023 Lubricant Pressure Keep(sec)
024 Lubricant Pressure Out Freq(Hz)
Range :
Unit :
Authority : Operation admin or higher
Default : 0
Effective time
Note
:
:
Instant
Set the schedule start and holding time of the automatic oil pump of the
system
Schedule open setting is that the settings of P6.045 oil pump output
ports when the timing reaches specified value after the system starts and
times.

Adtech CNC9640 Specifications

General

Brand	Adtech
Model	CNC9640
Category	Control Systems
Language	English