Total Access
®
3000/3010 System Manual
6TADLP725-1E
TOTAL ACCESS 3000/3010
DLP-725
Page 3 of 4
© 2002, ADTRAN, Inc.
Perform Steps Below in the Order Listed
press <Enter>.
4. Check the List of Shelves for Completeness
Check the list of shelves presented by the SCU to ensure that all shelves connected
on the bus appear. Each shelf should appear listed by CLLI Code and TIRKS ID
Number. The shelf containing the Host SCU should be distinguished by an
asterisk (*).
If a shelf does not appear on the list, check the following in order until the problem
is corrected:
• Verify the RS-485 bus wiring between the shelves (see DLP-712 for wiring
details).
• Verify that the shelf is powered and that the SCU is active.
• Verify that the shelf has been properly provisioned with a CLLI Code and
TIRKS ID Number.
• Verify that each shelf in the chain has a unique TIRKS ID Number.
• Verify that the shelf has the RS-485 bus enabled.
• Verify that only one SCU in the chain is configured for Host Mode.
5. Perform a Bank Connect to the Client Shelf
Pick the first Client shelf from the list. (Do not attempt to select the host shelf
from the list since this connection will not be allowed.) Type the number next to
the shelf and press <Enter> to perform a bank connect to that shelf. The main
menu for the shelf should be displayed.
If the main menu is displayed, then communication between the Host SCU and the
Client SCU is working properly. If communication fails, check the items listed in
the note from Step 4.
6. Disconnect from the Client Shelf
Press <Esc> to return to the Client Shelf’s main menu, then select option 6,
Logoff, and press<Enter>. The bank selection menu of the Host SCU will be
displayed.
7. Repeat the Bank Connect for each Client Shelf
Repeat Steps 5 and 6 for each Client Shelf in the chain.
To Next Page
Loading...
