Total Access
®
3000/3010 System Manual
6TADLP727-1E
TOTAL ACCESS 3000/3010
DLP-727
Page 4 of 4
© 2002, ADTRAN, Inc.
Perform Steps Below in the Order Listed
4. Perform an SNMP Query on the SCU
If the SCU is to be managed remotely using an SNMP Management Station, then
the network connection between the SCU and the Management Station should be
tested.
Contact the administrator of the SNMP Management System and provide
them with the IP Address and SNMP Community Name Strings for the
SCU. Have the administrator perform an SNMP query on the MIB II System
Group to ensure that the Management System can access the SCU.
If the SNMP Management System is unable to query the SCU, contact your
network administrator for assistance.
NOTE
The SNMP Community Name Strings are set on the Provisioning Menu of the
Network Management Interface. The default value for the Read Community
Name string is “public” and the Write Community Name string is “private”.
1.3 Followup Procedures
Once this procedure is complete, return to the procedure which called out this DLP and
continue with the tasks indicated there.
To Next Page
Loading...
