Total Access 3000/3010 System Manual
6TADLP728-1E
TOTAL ACCESS 3000/3010
DLP-728
Page 1 of 4
© 2003, ADTRAN, Inc.
Perform Steps Below in the Order Listed
1.1 Upgrading Software in the System Controller Unit
NOTE
References to common, but differing, parameters between the Total Access
3000 and the Total Access 3010, such as number of slots, will be conveyed
by the convention a/b. The “a” represents the Total Access 3000 parameter
and the ”b” represents the Total Access 3010 parameter. For example, the
differing number of access slots in the two platforms, 28 for the Total Access
3000 and 22 for the Total Access 3010, would be displayed “28/22.”
1.1.1 Introduction
This procedure provides step-by-step instructions for the upgrading the application
software in the System Controller Unit (SCU). This procedure offers instructions for
using either TFTP or Y-modem protocols for transferring the new software to the
SCU.
1.1.2 Prerequisite Procedures (TFTP)
The following procedures must be completed prior to attempting a software upgrade
on the SCU using TFTP. If necessary, refer to the appropriate documentation before
proceeding. The prerequisite procedures include:
• Installation and wiring of a Total Access 3000/3010 shelf and SCU – NTP-501
• Physical installation of the Multiplexer Module(s) to be used (MUXs are needed
only if the TFTP upgrade will be facilitated by the in-band management channel):
– DS3 MUX – NTP-504
– STS MUX – NTP-505
– OC-3 MUX – NTP-506
• Verifying SCU Communications over an IP LAN – DLP-727
To Next Page
Loading...
