ADTRAN Total Access 3000 - Page 426

Total Access
®
3000/3010 System Manual
6TADLP744-1E
TOTAL ACCESS 3000/3010
DLP-744
Page 8 of 12
© 2003, ADTRAN, Inc.
Perform Steps Below in the Order Listed
NOTE
In redundant applications, the System ID and the NSAP Area Address must
be entered in both the A and B OC-3 L2 MUX individually. These entries are
not automatically updated through Linked Provisioning.
23.) Verify that the Target ID (TID) has been automatically updated and is
the same as the Target ID (TID) that was entered at the Intelligent NE (Host)
Shelf SCU.
24.) Press <Esc> to return to the OC-3 Main Menu and select STS-1 Mapping.
25.) From the STS-1 Mapping screen, map STS-1 #1 to DS1 Drops, map STS-1
#2 to EC-1 #1, and map STS-1 #3 to EC-1 #2. The MUX Service State must
be either Out-of-service, Maintenance or Out-of-service, Unassigned to map
the STS-1s. This mapping is required for TIRKS OSS.
26.) Press <Esc> to return to the OC-3 Main Menu and select VT1.5 Mapping.
27.) From the VT1.5 Mapping screen, select M13 1-to-1 Mapping. This is
required for TIRKS OSS.
28.) Press <Esc> to return to the Total Access Main Menu.
9. Provision STS-1 List 2 MUX in the Expansion Shelves (Client)
1.) Access the menus for the Expansion Shelf (Client) by either connecting
through the front panel craft port (see DLP-715) or by Telnet session if
connected to the LAN.
2.) From the Main Menu, select the STS-1 MUX.
3.) From the STS-1 Main Menu, select Provisioning.
4.) Verify Linked Provisioning is Enabled.
5.) Verify Clock Source is set to Receive STS-1 Loop.
6.) Select DCC Mode and set to Disabled.
7.) Press <Esc> to return to the STS-1 Main Menu and select VT1.5 Mapping.
8.) From the VT1.5 Mapping screen, select M13 1-to-1 Mapping. This is
required for TIRKS OSS.
9.) Press <Esc> to return to the Total Access Main Menu.
10.)Repeat section 1.2.9 above for each of the Expansion Shelves.