AERMEC MULTI CONTROL - Parameter Matching with Unit Types

19
4598010_00
GB
Label Description
ANL ANLi
ANR
ANF
SRPV1
ANL-C WRL
(1)
ANKi
TYPE Type of unit
✔✔✔
(2)
✔✔✔
TIA Water inlet temperature
✔✔✔✔✔✔
TUA Water outlet temperature
✔✔✔✔✔✔
TSB Coil temperature
✔✔✔✔✖✔
TGP Pressing gas temperature
✔✔✔✔✖✔
SIWH Condenser inlet water temperature
✖✖✖✖✔✖
SUWH Condenser outlet water temperature
✖✖✖✖✔✖
TAE External air temperature
✔✔✔✔✔✔
AP High pressure
✔✔✔✔✔✔
BP Low pressure
✔✔✔✔✔✔
HC0 Primary circuit compressor operating hours
✔✔✔✔✔✔
SP0 Primary circuit compressor start-ups
✔✔✔✔✔✔
REL Software relay (MAIN)
✔✔✔✔✔✔
BLD Software relay (SECONDARY)
✔✔✔✔✔✔
SET Current work setting of chiller
✔✔✔✔✔✔
HC1 Secondary circuit compressor operating hours
✔✔✔✔✔✔
SP1 Secondary circuit compressor start-ups
✔✔✔✔✔✔
STF Set-point at cooling
✔✔✔✔✔✔
STC Set-point at heating
✔✔✔✔✔✔
SAS Set-point at DHW
✔✔✔✔✔✔
PT Power percentage requested by the thermostat
✔✔✔✔✔✔
PO
Power supply by unit (On-Off) or
frequency in use (units with inverter compressors)
✔✔✔✔✔✔
(1)
Only models with MODUCONTROL board (WRL cooling only from size 025 to size 160).
(2)
For these units, the TYPE parameter will read the generic R407.
Parameter present =
✔
Parameter NOT present =
✖
Matching between operating parameters and units: