AERMEC MULTI CONTROL User Manual

43
4598010_00
GB
The sixth window of the DHW SETUP allows the installer
to set a delta to be applied to the DHW setting of the units
used for the production of domestic hot water; this function
makes it possible to partialise units which produce domestic
hot water (when there are several units producing domestic
hot water), by moving the settings of these units by the
value specifi ed in this parameter; this window displays the
following information:
- Hysteresis delta to be applied to the units (
1
): indicates
the value with which to shift the DHW production settings of
the secondary units, as indicated in the layout below.
From this window it is possible to:
(1) Set a hysteresis delta: pressing the key
C
will allow you to
enter the modifi cation mode and the value will be highlighted; by
pressing the keys
A
or
B
it will be possible to modify the value
currently displayed, while pressing the key
C
will confi rm this
choice.
(2) Pass on to the next window:
to go to the next window of this menu, press the key
B
.
(3) Go back to the previous window:
to go back to the previous window of this menu, press the
key
A
.
(4) Exit this window:
press the key
F
to return to the selection of the USER menus.
• Setting a hysteresis delta in DHW production with several units (Password 303):
TAS
1
DHW production logic with hysteresis delta
TAS = DHW storage tank temperature.
Unit 1 DHW
setting
Off On On Off
Unit 2 DHW
setting
Off On On Off
Unit 3 DHW
setting
Off On On Off
1
A
B
C
ESC
D
1
Shift DHW set point
03.0
o
C
Shift DHW set point
03.0
o
C

AERMEC MULTI CONTROL Specifications

General

Brand	AERMEC
Model	MULTI CONTROL
Category	Control Panel
Language	English