AERMEC MULTI CONTROL User Manual

44
GB
4598010_00
The seventh window of the DHW SETUP allows the installer
to set the defrosting direction (on the system or on DHW)
should defrosting occur during DHW production; this window
displays the following information:
- Defrosting direction (
1
): indicates the current direction
given to the produced water if a defrosting cycle is triggered
during DHW production.
From this window it is possible to:
(1) Set defrosting direction during DHW production: pressing
the key
C
will allow you to enter the modifi cation mode and the
value will be highlighted; by pressing the keys
A
or
B
it will be
possible to modify the value currently displayed, while pressing
the key
C
will confi rm this choice; the values can be:
- DHW (the water fl ow will remain in the DHW circuit);
- SYSTEM (the water will fl ow towards the system; in this case the
fl ow rate control will be disabled for the amount of time specifi ed
in the relative parameter to keep fl ow switch alarms from being
triggered during the quick change of the valve).
(2) Go back to the previous window:
to go back to the previous window of this menu, press the
key
A
.
(3) Exit this window:
press the key
F
to return to the selection of the USER menus.
• Setting the defrosting direction during DHW production (Password 303):
A
B
C
ESC
D
1
Defrost position
DHW
Defrost position
DHW

AERMEC MULTI CONTROL Specifications

General

Brand	AERMEC
Model	MULTI CONTROL
Category	Control Panel
Language	English