45
4598010_00
GB
Setup menu
- SYSTEM SETUP procedures
The fi rst window of the SYSTEM SETUP allows the user to
set the type of remote control (if present) to be applied to
the MULTI CONTROL; this window displays the following
information:
- Type of remote control (
1
): indicates which type of
remote control is currently applied to the MULTI CONTROL
accessory.
From this window it is possible to:
(1) Set the type of remote control: pressing the key
C
will allow you to enter the modifi cation mode and the value
will be highlighted; by pressing the keys
A
or
B
it will
be possible to modify the value currently displayed, while
pressing the key
C
will confi rm this choice; the values that
can be set with this parameter are:
- BY VMF CRP 3 MODULE (indicates that remote control is
performed by the installed VMF CRP 3 accessory module;
for further information, see the installation section of the
components of the system in this manual).
- BY MODBUS SERIAL (indicates that the system is controlled by a
BMS supervision system; this system is implemented by using the
list of variables specifi ed on the following pages).
- NOT PRESENT (no remote control included).
(2) Pass on to the next window:
to go to the next window of this menu, press the key
B
.
(3) Exit this window:
press the key
A
to return to the selection of the SETUP menus.
(4) Exit this window:
press the key
D
to return to the selection of the USER menus.
• Setting remote control (Password 101 or 303):
A
B
C
ESC
D
Remote control
NOT
AVAIBLE
1
Remote control
NOT
AVAIBLE
To Next Page
Loading...
