33
4598010_00
GB
The second window of the UNIT SETUP allows the user to set
the working mode at cooling (invalid if heating only units are
installed in the system); this window displays the following
information:
- Index of the unit to which the setting refers (
1
): indicates
which unit (1, 2, 3 or 4) the work setting refers to.
- Cooling setting (
2
): indicates the cooling operating set-
point of the units managed by MULTI CONTROL.
From this window it is possible to:
(1) Select a unit to set at cooling mode: pressing the keys
D
or
E
decreases or increases the index which indicates which unit
the work setting currently displayed refers to (
1
); remember
that each unit can be set with different work settings
.
(2) Setting at cooling mode: pressing the key
C
will allow you
to enter the modifi cation mode and the value will be highlighted;
by pressing the keys
A
or
B
it will be possible to modify the set
value, while pressing the key
C
will confi rm this choice.
(3) Pass on to the next window:
to go to the next window of this menu, press the key
B
.
(4) Go back to the previous window:
to go back to the previous window of this menu, press the
key
A
.
(5) Exit this window:
press the key
F
to return to the selection of the USER menus.
• Setting working mode at COOLING (Password 101 or 303):
A
B
C
ESC
F
Cold setpoint
12.0
o
C
N:1
DE
Cold setpoint
12.0
o
C
N:1
1
2
To Next Page
Loading...
Need help?
General
