AERMEC MULTI CONTROL - Setting BMS Serial Port Address

50
GB
4598010_00
The third window of the SYSTEM SETUP allows the installer to
set the address of the serial port used for BMS systems; this
window displays the following information:
- Current address of BMS serial port (
1
): indicates the
address currently set for the serial port of the supervision
systems.
From this window it is possible to:
(1) Set the address of the BMS serial port: pressing the
key
C
will allow you to enter the modifi cation mode and
the value will be highlighted; by pressing the keys
A
or
B
it will be possible to modify the value currently displayed,
while pressing the key
C
will confi rm this choice; the values
possible for this parameter are within the range 0
~
247.
(2) Pass on to the next window:
to go to the next window of this menu, press the key
B
.
(3) Go back to the previous window:
to go back to the previous window of this menu, press the
key
A
.
(4) Exit this window:
press the key
D
to return to the selection of the USER menus.
• Setting the address of the serial port of the supervisor (Password 303):
A
B
C
ESC
D
Address
000
1
Address
000