AERMEC MULTI CONTROL User Manual

31
4598010_00
GB
The fi rst window of the SETUP MENU allows the user to enter
the password to access the protected parameters of the
MULTI CONTROL device; there are two levels:
- USER level (contains the operating parameters which can
freely be set by the user).
- INSTALLER level (contains both the operating parameters
of the user level and the specifi c parameters the setting
or modifi cation of which is RESERVED to installation or
assistance personnel of the units insofar as an incorrect
setting of the values in these parameters could cause the
units to be damaged or malfunction); this window displays
the following information:
- Password (
1
): indicates the password to access the
various submenus.
- Software version (
2
): indicates the software version
currently installed on the device.
From this window it is possible to:
(1) Enter an access password: pressing the key
C
will allow you
to enter the modifi cation mode and the value of the password will
be highlighted; by pressing the keys
A
or
B
it will be possible
to modify the fi rst digit, while pressing the key
C
will confi rm the
value, automatically selecting the next digit; the selection and
confi rmation procedure will be repeated for all three digits; after
the third digit has been confi rmed, you will access the submenus
of the level to which the password referred, or, if the password is
incorrect, an error message will appear.
(3) Exit this window:
press the keys
A
or
D
to return to the selection of the menus.
• Entering password for level selection:
SETUP MENU procedures
!
The password values are:
USER LEVEL = 101
INSTALLER LEVEL = 303
ESC
D
A
B
C
Insert password
000
VS:1.0.0
Insert password
000
VS:1.0.0
1
2

AERMEC MULTI CONTROL Specifications

General

Brand	AERMEC
Model	MULTI CONTROL
Category	Control Panel
Language	English