To Next Page

To Previous Page

Agilent 1260 Infinity DAD and MWD User Manual 133

Error Information

General Error Messages

2 If it is desired that the system has only one leak drain tube, then it's

possible in increase the length of the small plastic tube which is connected

to port# 4 of the sampler switching valve. This tube can then be taken to

waste separately. The tube which normally serves as the detector cell outlet

tube can be used for this purpose.

Open Cover

Error ID: 0205

The top foam has been removed.

The sensor on the main board detects when the top foam is in place. If the

foam is removed, the fan is switched off, and the error message is generated.

Cover Violation

Error ID: 7461

The top foam has been removed.

The sensor on the main board detects when the top foam is in place. If the

foam is removed while the lamps are on (or if an attempt is made to switch on

for example the lamps with the foam removed), the lamps are switched off,

and the error message is generated.

Probable cause Suggested actions

The top foam was removed during

operation.