Agilent Technologies 1260 Infinity G1315D User Manual

270 Agilent 1260 Infinity DAD and MWD User Manual
13 LAN Configuration
Dynamic Host Configuration Protocol (DHCP)
Setup (DHCP)
1 Note the MAC address of the LAN interface (provided with G1369C LAN
Interface Card or Main Board). This MAC address is on a label on the card
or at the rear of the main board, e.g. 0030d3177321.
On the Instant Pilot the MAC address can be found under Details in the LAN
section.
Figure 92 LAN Setting on Instant Pilot
2 Set the Configuration Switch to DHCP either on the G1369C LAN Interface
Card or the main board of above mentioned modules.
Software required The modules in the stack must have at least firmware from set A.06.34 and the above mentioned
modules B.06.40 or above (must from the same firmware set).
Tabl e 3 1 G1369C LAN Interface Card (configuration switch on the card)
SW 4SW 5SW 6SW 7SW 8Initialization Mode
ON OFF OFF OFF OFF DHCP

Agilent Technologies 1260 Infinity G1315D Specifications

General

Brand	Agilent Technologies
Model	1260 Infinity G1315D
Category	Laboratory Equipment
Language	English