264 Agilent 1260 Infinity DAD and MWD User Manual
13
LAN Configuration
Configuration Switch
Configuration Switch
The configuration switch can be accessed at the rear of the module.
Figure 86 Location of Configuration Switch
The module is shipped with all switches set to OFF, as shown above.
To perform any LAN configuration, SW1 and SW2 must be set to OFF.
Tabl e 2 8 Factory Default Settings
Initialization (‘Init’) Mode Bootp, all switches down. For details see “Initialization
mode selection” on page 265
Link Configuration speed and duplex mode determined by auto-negotiation, for
details see “Link configuration selection” on page 272
To Next Page
Loading...
Need help?
General
