5-17
To Set Analysis Functions
Function Setup
Data calculation
-Measurement data/source data
-Read out function
-Built-in function, etc.
The analysis functions can be displayed on the Parameters area of the Data Display window. Up
to 20 functions can be set.
Name: Function name
Unit: Unit of the function
Definition: Definition of the function. The following identifiers can be used.
-Variables for the measurement/output data used in this test
-Functions defined in the above lines
-Local variables passed from the application test that calls this test as a component
-Built-in functions and global variables
-Read out functions
For details, see online help or User’s Guide.
Note:
The Apply button performs calculation of the definition in this screen. If this button is clicked
when the Data Display window associated with this test has been opened, the display is also
updated. The associated Data Display window will be the Data Display window that displays the
last measurement data or that is recalled at last.
To Next Page
Loading...
Need help?
General
