Agilent Technologies PlateLoc User Manual

3
Chapter 1: PlateLoc introduction
PlateLoc User Guide
In a third-party lab automation system
You can set up the PlateLoc in a third-party lab automation system. To
install the PlateLoc in the system, you must connect the device to the
controlling computer. You can operate the integrated PlateLoc using the
third-party software. The integrated PlateLoc allows you to automate the
loading and sealing of multiple plates in one run.
Note: Communication between the third-party system and the PlateLoc
is achieved through the use of ActiveX controls.
Related topics
For more information about... See...
PlateLoc physical dimensions “Meeting Lab requirements” on page 23
Installing the PlateLoc “Unpacking and installation” on
page 21
How to use the PlateLoc as a
standalone device
“Standalone device workflow” on
page 16
Setting up the PlateLoc in a lab
automation system
❑ “Lab automation system software”
on page 14
❑ “Integrating the PlateLoc into third-
party systems” on page 99
How to use the PlateLoc in a lab
automation system
“Lab automation system workflow” on
page 17

Agilent Technologies PlateLoc Specifications

General

Brand	Agilent Technologies
Model	PlateLoc
Category	Laboratory Equipment
Language	English