67
Chapter 4: Sealing plates
PlateLoc User Guide
Lab automation
system procedure
If the PlateLoc is installed in a lab automation system, you need to load
the insert before you start the protocol run. During the run, the robot
loads the plates automatically. You do not need to manually load each
plate.
Related topics
For more information about... See...
Turning on the PlateLoc “Turning on and turning off the power”
on page 42
Turning on the air “Turning on and turning off the air” on
page 44
Loading a roll of seal “Loading and unloading a roll of seal”
on page 53
Plate requirements “Plate requirements” on page 9
Using inserts “Inserts” on page 10
Optimizing seal quality “Optimizing seal quality” on page 77
Operating the PlateLoc in a lab
automation system
“Lab automation system workflow” on
page 17
To Next Page
Loading...
Need help?
General
