Introduction 1
Preparing Your LCR Meter
U1731C/U1732C/U1733C User’s Guide 3
Preparing Your LCR Meter
Check the shipment
When you receive your LCR meter, check the shipment
according to the following procedure.
1 Inspect the shipping container for damage. Signs of
damage may include a dented or torn shipping container
or cushioning material that indicates signs of unusual
stress or compacting. Save the packaging material in case
the LCR meter needs to be returned.
2 Carefully remove the contents from the shipping
container, and verify that the standard accessories and
your ordered options are included in the shipment
according to the standard shipped items list found in the
printed copy of the U1731C/U1732C/U1733C Quick Start
Guide.
3 For any question or problems, refer to the Agilent contact
numbers on the back of this manual.
Install the battery
Your LCR meter is powered by a single 9 V alkaline battery
(included with the shipment). When you receive your LCR
meter, the 9 V alkaline battery is not installed.
Use the following procedure to install the battery.
Before you proceed with the battery installation, remove all cable
connections to the terminals and ensure that the LCR meter is turned
OFF. Use only the battery type specified in “Product Characteristics” on
page 76.
To Next Page
Loading...
Need help?
General
