3Setup Options
Setup Menu Items
70 U1731C/U1732C/U1733C User’s Guide
Changing the data bits
This setting is used with the IR communication link and the
Agilent GUI Data Logger software to control your LCR meter
remotely (page 9).
Use this Setup item to change the number of data bits (data
width) for remote communications with a PC. The number of
the stop bit is always 1, and this cannot be changed.
Figure 3-12 Changing the data bits
Parameter Range Default setting
dAt 7-bit or 8-bit 8-bit
To Next Page
Loading...
