Setup Options 3
Setup Menu Items
U1731C/U1732C/U1733C User’s Guide 61
Changing the power-on secondary parameter and measurement
mode for resistance (R) measurements
Use this Setup item to change the resistance (R)
measurement’s initial secondary parameter — dissipation
factor (D), quality factor (Q), or phase angle (θ) — and
measurement mode — parallel or series.
The resistance (R) measurement will start up using the
selected secondary parameter and measurement mode for
subsequent power cycles.
Figure 3-5 Changing the power-on secondary parameter and measure-
ment mode for resistance (R) measurements
Pr e s s
Pr e s s
Pr e s s
Pr e s s
Pr e s s
Pr e s s
Pr e s s
Pr e s s
To Next Page
Loading...
Need help?
General
