2 Features and Functions
Additional Features
44 U1731C/U1732C/U1733C User’s Guide
While the annunciator is flashing, use the or
key to select an appropriate limit set.
You may press or again to toggle between the high
(H) or low (L) values shown on the primary display.
Figure 2-16 High and low limit values
Press while the annunciator is flashing to start
the comparison. (If no activity is detected after 3 seconds,
the comparison will also begin.)
The LCR meter beeps three times and displays in the
secondary display if the reading is greater ( ) than the
high limit or lesser ( ) than the low limit.
If the reading is within the high and low limits, the meter
beeps once and displays in the secondary display.
Figure 2-17 nGo and Go indications
The limit set used in the comparison is displayed after the
/ indication.
To Next Page
Loading...
Need help?
General
