Contact: AIRSYS North America Phone: (855) 874-5380 Page 15 of 112
Email: ASNSupport@air-sys.com Web: http://airsysnorthamerica.com Rev 1.15
any damage to the equipment that relates directly to the damage observed to the external packaging.
Without the detailed photos, it will be very difficult to recover equipment loss.
Warranty
The warranty duration is 12 months from the date of installation. AIRSYS warrants that its products will be
free from defects in materials and workmanship for a period of 12 months after installation.
The compressor is to be free from defects in material or workmanship for a period of 60 months from
date of installation.
Important. For sites equipped with a generator, when the generator switches to the primary
source of power, the instantaneous voltage may become lower. If this is the case, the compressor
may run at a lower voltage which can decrease the compressor’s working life. Make sure the Gen-Run
signal input is connected which can protect the compressor. The warranty does not cover damage to the
compressor caused by repetitive out of specification supply voltage during compressor operation.
AIRSYS will furnish free of charge replacement parts for any component failures that occur within the
warranty period. Customer is responsible for the cost of shipment of replacement material from AIRSYS
North America.
Note: Warranty assumes that an AAST performs the installation and submits the warranty registration
card that accompanied the units in shipment. If the warranty registration card was not filled out and
returned to the supplier, then the warranty will be assumed to expire 12 months from the date of
shipment for all components except the compressor, which will be assumed to expire 60 months from
date of shipment.
This warranty does not cover damage to the systems caused by misuse or abuse of the systems such as
physical damage due to mishandling. The warranty does not cover damage caused by force majeure.
Important. Any mishandling of the equipment or modifications to the equipment, unless agreed
upon in writing by AIRSYS, will void the warranty.
Moving the Unit
Forklifts are recommended for moving, loading, unloading, and positioning the WPU for installation. If
bands or ropes are used to create a sling, make sure that excessive force is not applied to the upper
edges of the machines or the package to avoid cosmetic or material damage. When using spacing bars,
protective materials are required around the units to prevent damage. To avoid damage to the units while
moving or transporting, ensure the units always remain in the upright position.
Note: The 28V1B5 unit may not be compatible with pallet jacks due to low pallet height. Loading dock
facilities or lift gate equipped vehicles are recommended when transporting the unit.
Note: A crane will be required to lift the 28V1B5 unit during installation due to its weight (1370 lb/621
kg).
To Next Page
