AIRSYS UNICOOL 11V1T3 - System Menu Parameters; Debug and Hardware Configuration Menu Parameters

Contact: AIRSYS North America Phone: (855) 874-5380 Page 80 of 112
Email: ASNSupport@air-sys.com Web: http://airsysnorthamerica.com Rev 1.15
System Menu Parameters
Table 30: Parameters in the System Menu
Menu Screen
Option
Description
Date/Time
Format
Date Format
Date
System Date
Hour
System Time (24 hr clock)
Day
Day of the week
Serial Ports
Baudrate
Change baud rate
Pwd Change
Change Password
Change system passwords
Initialization
Clear alarm logs
Change “No” to “Yes” to clear logs
Clear AutoReset Counters
Change “No” to “Yes” to clear
counters
Wipe retain mem
Wipe memory
Wipe NVRAM
Wipe storage
Wipe both
Wipe memory and storage
Reboot System
Change “No” to “Yes” to reboot
controller
Reboot HVAC
Reboots selected HVAC. Change “No”
to “Yes” to reboot HVAC unit.
Debug and Hardware Configuration Menu Parameters
The Debug and Hardware Configuration Menus contain configuration options for all controller modules.
Settings changed here from the controller box will not carry over to the individual units. No password is
required to access these options.
Note: The Debug Menu should not be accessed outside of initial startup or system update. To enter the
Debug Menu, press Up and Down at the same time from the main screen.
Table 31: Debug Menu Options
Menu Screen
Option
Description
Master/HVAC Select
Master/HVAC
Select between Master and HVAC controller operation
Conversion
Unit Conversion
Change between different unit systems
Operation Mode (Unit
Only)
Operation Mode
Select between normal and fixed speed operation
Work alone mode
Work alone mode
Set up unit for operation without an ASMUC.6 controller