Contact: AIRSYS North America Phone: (855) 874-5380 Page 14 of 112
Email: ASNSupport@air-sys.com Web: http://airsysnorthamerica.com Rev 1.15
Chapter 3: Installation
Installation Preparation
Unpack the unit carefully. Some parts are packed loosely and may move as the packaging is opened.
Before discarding the box, check the packaging carefully for any parts or documents inside. Refer to Table
3 on Page 16 for the complete list of materials shipped with each unit.
Check that:
The supply voltage meets the requirements as designated: 197-252VAC, 36-57VDC.
• The install location is clean on the inside and free of excess dirt and dust.
• Minimum install clearances are met (see “Clearances” on Page 20).
• All installer provided items, listed in Table 4 on Page 18 are accounted for.
Installation and startup must be performed by an AIRSYS Authorized Service Technician (AAST). For more
information about the AAST program, please contact:
AIRSYS North America
ASNSupport@air-sys.com
855-874-5380
Danger. All the installation work must be done by professional technicians. Installation that does
not comply with the instructions herein can result in the loss of warranty coverage. AIRSYS shall not
be held liable for any damage caused to persons or objects due to incorrect installation or operation of
the units.
Warning. All wiring must comply with the local safety standards and building codes under all
circumstances.
Warning. Risk of electric shock can cause injury or death: disconnect all remote electric power
supplies before installation.
When no longer in use, disposal of equipment and materials must be compliant with local laws and
standards.
Delivery
When the units are delivered, be sure to inspect them to verify that they have not been damaged during
transport. Also verify that all requested accessories listed on the purchase order have been included.
Important. If packages show any signs of shipping damage or potential shipping damage, it is
very important to annotate
shipping damage
on the Bill of Lading prior to signing for the freight.
In order to recover for any damage, please take detailed photographs of all the packaging before the
external packaging is removed. Once detailed photos of the external packaging have been taken, then the
external packaging may be removed so the items can be inspected further. Please document with photos
To Next Page
