System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 389
provides for use of all available resources exclusively by MAC criteria egress filter policies and
provide larger number of policies to be used.
The resources cannot be shared with any other egress filter policies that specify other match criteria.
Please see the 7210 SAS Router Configuration guide for more information on resource allocation
details and fields available for use.
With the no form of the command, the software does not allocate any resources for use by egress filter
policies using MAC criteria. If no resources are allocated for use, then the software fails all attempts
to associate a service entity (e.g. SAP, IP interface, etc.) with a filter policy using this match criteria.
Note that, its possible to use MAC policies by allocating resources that are shared with other match
criteria. This option allows for better scaling.
Default no mac-match-enable
Parameters num-resources — Specifies the maximum amount of resources for use by this filter match criteria.
Values [0|2]
ingress-internal-tcam
Syntax ingress-internal-tcam
Context configure>system>resource-profile
Description This command provides the context to allocate ingress internal TCAM resources.
acl-sap-ingress
Syntax [no] acl-sap-ingress
Context configure>system>resource-profile>ingress-internal-tcam
Description This command allows the user to allocate maximum resources for use by ingress filter policies using
any of the supported match criteria. This command limits the total amount of chunks allocated for use
by ingress filter policies to the value specified by num-resources. In other words, the cumulative sum
of chunks allocated to different match criteria supported by ingress filter policies cannot exceed the
value configured with num-resources.
NOTE: On 7210 SAS-K, when resources are allocated to ingress ACLs from the ingress internal
tcam pool, these resources can be used by either MAC criteria entries, IPv4 entries and entries that
use only IPv6 64-bit addresses.
With the no form of the command, software does not allocate any resources for use by filter policies.
If no resources are allocated for use, then the software fails all attempts to associate a service entity
(For example: SAP, IP interface, etc.) with a filter policy using any of the match criteria.
Parameters num-resources — Specifies the amount of resources that can be allocated for use by ACL policies.
To Next Page
Loading...
Need help?
General
