Configuring the 7210 SAS-T
7210 SAS-T Installation Guide Page 69
Configure the primary-config in the BOF and save the config:
A:SN12# bof primary-config cf1:/config.txt
*A:SN12# bof save
Writing BOF to cf1:/bof.cfg
Saving BOF .... Completed.
A:SN12# admin save
Writing file to cf1:\config.txt
Saving configuration .... Completed.
A:SN12#
Copy the TiMOS image from the FTP server to the flash:/
A:SN12# system security source-address application ftp in-band-mgmt
A:SN12# file copy ftp://<user>:<passwd>@10.10.170.22/./images/both.tim cf1:/both.tim
Copying file ftp://<user>:<passwd>@10.10.170.22/./images/both.tim...
1 file copied.
A:SN12#
Configure the BOF to pick up the image from internal flash:
A:SN12# bof primary-image cf1:/both.tim
*A:SN12# bof save
Writing BOF to cf1:/bof.cfg
Saving BOF .... Completed.
A:SN12#
Reboot the 7210 SAS-T. The device will pick up both the image and the configuration from the
internal flash.
Note: If you have used the USB storage device or the external compact flash, the images boot.tim and
both.tim can be copied to the internal flash (cf1:\) by using the file copy CLI commands. If you intend to
boot the device from the new location, remember to configure and save the BOF file appropriately.
To Next Page
Loading...
