Configuring the 7210 SAS-T
7210 SAS-T Installation Guide Page 61
Relocating code...Jumping to RAM
Performing second stage RAM test....passed
Board Serial Number is 'SN12345678'
Bootlog started for Version V-1.0.R1
Build V-1.0.R1 bootrom/mpc 7xxx
Built on Thu Jan 15 14:55:59 IST 2009 by builder in /builder/ws/panos/main
Since the router does not ship with a BOF, it will show the default settings.
Looking for cf1:/bof.cfg ... not found
Could not find bof.cfg on any of the local drives.
Default Settings:
-------------------------------------------------------------------------------------
------------
Contents of Boot Options File on cf1:
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/1
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
Hit a key within 2 seconds to change boot parameters...
Press any key.
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
Password:
The default password is password.
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
"reset" - reset the bof and reboot.
To Next Page
Loading...
