Alcatel-Lucent 7210 SAS-T User Manual

In-Band Access
Page 78 7210 SAS-T Installation Guide
In-Band Access
You can access the management agent in the switch from anywhere within the
attached network using Telnet or network management software tools. However, you
must first configure the switch with a valid IP address, subnet mask, and default
gateway.
If you have trouble establishing a link to the management agent, check to see if you
have a valid network connection. Then verify that you entered the correct IP address.
Also, be sure the port through which you are connecting to the switch has not been
disabled. If it has not been disabled, then check the network cabling that runs between
your remote location and the switch.
NOTE:
The management agent can accept up to seven simultaneous Telnet sessions. If the maximum
number of sessions already exists, an additional Telnet connection will not be able to log into the
system.

Alcatel-Lucent 7210 SAS-T Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-T
Category	Switch
Language	English