Initializing the System and Downloading Software
Page 68 7210 SAS-T Installation Guide
Downloading the TiMOS Software to the Internal Flash
If you want to boot the 7210 SAS-T from the internal flash, you will have to copy the image there.
If you have used the uplinkA or uplinkB port to boot the 7210, use any of the network ports for IP
connectivity and follow the procedure given below to configure an IP interface and a route.
If you have used the out-of-band ethernet management port, then you do not need to configure the
IP interface. Instead jump to the step "Check IP connectivity" below and continue from there.
Change the mode of the connected port to network.
A:SN12# configure port 1/1/24
A:SN12>config>port#
A:SN12>config>port# ethernet mode network
A:SN12>config>port# no shutdown
A:SN12>config>port# exit
Configure an IP interface:
A:SN12# configure router
A:SN12>config>router# info
----------------------------------------------
interface "in-band-mgmt" create
address 10.135.4.172/24
port 1/1/24
exit
----------------------------------------------
A:SN12>config>router#
Configure a route to the FTP server.
A:SN12#configure router
A:SN12>config>router#
A:SN12>config>router# static-route 10.10.170.0/24 next-hop 10.135.4.1
A:SN12>config>router#
Check IP connectivity:
A:SN12# ping 10.10.170.22 source 10.135.4.172
PING 10.10.170.22 56 data bytes
64 bytes from 10.10.170.22: icmp_seq=1 ttl=251 time<1ms.
64 bytes from 10.10.170.22: icmp_seq=2 ttl=251 time<1ms.
64 bytes from 10.10.170.22: icmp_seq=3 ttl=251 time<1ms.
64 bytes from 10.10.170.22: icmp_seq=4 ttl=251 time<1ms.
64 bytes from 10.10.170.22: icmp_seq=5 ttl=251 time<1ms.
---- 10.10.170.22 PING Statistics ----
5 packets transmitted, 5 packets received, 0.00% packet loss
round-trip min < 1ms, avg < 1ms, max < 1ms, stddev < 1ms
A:SN12#
To Next Page
Loading...
Need help?
General
