Alcatel-Lucent 7210 SAS-T User Manual

Initializing the System and Downloading Software
Page 62 7210 SAS-T Installation Guide
Press ENTER to begin, or 'flash' to enter firmware update...
Press Enter.
Software Location
-----------------
You must enter the URL of the TiMOS software.
The location can be on a Compact Flash device,
or on the network.
Here are some examples
cf1:/timos1.1R1
ftp://user:passwd@192.168.1.150/./timos1.1R1
tftp://192.168.1.150/./timos1.1R1
Software Image URL:
Enter the software URL. (For example,
ftp://<user>:<password>@10.10.170.22/./images/both.tim)
Configuration File Location
---------------------------
You must enter the location of configuration
file to be used by TiMOS. The file can be on
a Compact Flash device, or on the network.
Here are some examples
cf1:/config.cfg
ftp://user:passwd@192.168.1.150/./config.cfg
tftp://192.168.1.150/./config.cfg
No existing Config URL
Press Enter, or type 'none' for no Config URL.
Config File URL:
Enter the location of the configuration file or none since you are booting for the first time.
Boot Interface Management
-------------------------
You specified a network location for either the
software or the configuration file. You need to,
configure either uplinkA or uplinkB ports.
You will be asked to configure the port number, IP address,
static routes, and VLAN Id for uplink ports.
uplinkA Port Setting
--------------------
Existing uplinkA port settings are:
uplinkA-port 1/1/1
Note: The restart command can be used at any time to start off at the beginning of the menu
options.

Alcatel-Lucent 7210 SAS-T Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-T
Category	Switch
Language	English