In the CLI
[no] airgroup active-domain <string>
Sample Configuration
(host) (config) #airgroup active-domain campus1
(host) (config) #airgroup active-domain campus2
Viewing an AirGroup active-domains
The following procedure displays a list of AirGroup active-domains configured:
In the WebUI
1. Navigate to Configuration > Advanced Services > AirGroup.
2. Select the AirGroup Settings tab. The Active-Domain and Status column displays a list of AirGroup
active-domains under the AirGroup Domains section.
In the CLI
show airgroup active-domains
Viewing AirGroup VLAN Table
The following procedure displays the disallowed AirGroup VLANs.
In the WebUI
1. Navigate to Configuration > Advanced Services > AirGroup.
2. Select the AirGroup Settings tab. The list of disallowed AirGroup VLANs are displayed under the VLAN
Table section.
In the CLI
For the CLI command, see Viewing An AirGroup Disallowed VLAN on page 1015
Viewing AirGroup Multi-Switch Table
All switches communicate with each other based on the multi-switch table in an AirGroup cluster. This table is a
combination of switches specified in each domain, as part of active-domains.
The following command displays the IP address of all the switches participating in an AirGroup multi-switch
environment:
In the CLI
show airgroup multi-controller-table
Switch Dashboard Monitoring
The Dashboard > Usage page of the WebUI has an additional AirGroup section, which displays all the
AirGroup services available and number of servers offering the service. It is aggregated by the total number of
AirGroup servers sorted by the services they advertise.
AOS-W 6.5.3.x | User Guide AirGroup | 1018
To Next Page
Loading...