Alcatel-Lucent AOS-W 6.5.3.x - Configuring Hotspot 2.0 Profiles

895| 802.11u Hotspots AOS-W 6.5.3.x| User Guide
Profile Description
H2QP Operator Friendly Name
profile
Use this profile to define the operator-friendly name sent by
devices using this profile.
For more information on configuring this profile, refer to
Configuring H2QP Operator Friendly Name Profiles on page 912
H2QP WAN Metrics profile Use this profile to specify the WAN status and link metrics for your
hotspot.
For more information on configuring this profile, refer to
Configuring H2QP WAN Metrics Profiles on page 914
H2QP OSU Provider List profile This profile defines a list of OSU service providers available from
the hotspot.
For more information on configuring this profile, refer to
Configuring H2QP OSU Provider List Profiles on page 915
AP Prerequisites for Hotspot Support
Table 207 lists configuration requirements for virtual APs using AOS-W hotspot features:
Hotspot 1.0 Hotspot 2.0 OSEN
n WPA AES
Enterprise
(Not a
pre-
shared
key [PSK])
n WPA AES Enterprise (Not a pre-shared key [PSK])
n Protected management frames
n A Virtual-AP forwarding mode that supports protected managed frames.
(For example, tunnel forwarding mode does not support protected
management frames)
n An external authentication server or Clearpass server that supports
Hotspot 2.0
n WPA AES
Enterprise
(Not a pre-
shared key
[PSK])
n An external
authentication
server or
Clearpass
server that
supports
Hotspot 2.0
Table 207: AP Requirements
Configuring Hotspot 2.0 Profiles
Use this profile to enable support for Hotspot 2.0 R2 and define venue and OI settings for roaming partners.
Each hotspot 2.0 profile also references an advertisement profile, which defines a set of ANQP or H2QP
profiles that define other values for the hotspot feature. By default, Hotspot 2.0 profiles reference the
default advertisement profile.
For information on associating a different advertisement profile with a Hotspot 2.0 profile, see Configuring
H2QP OSU Provider List Profiles on page 915.
In the WebUI
To configure a Hotspot 2.0 profile from the switch WebUI:
1. Navigate to Configuration > Advanced Services > All Profiles.
2. In the Profiles list, expand the Wireless LAN section.
3. Select Hotspot 2.0.
4. Select an existing profile from the Profile Details pane or create a new profile by entering a profile name
into the entry blank, and then clicking Add.
5. Configure the parameters described in Table 208 as desired, and then click Apply.