Alcatel-Lucent AOS-W 6.5.3.x - Understanding AOS-W Supported Network Configuration for Ipv6 Clients

To configure a DHCP network, use the following command:
(host)(config-dhcpv6)#network <network-prefix>
To configure a client specific option, use the following command:
(host)(config-dhcpv6)#option <code> [ip <ipv6-address> | text <string>]
To configure DHCP server preference, use the following command:
(host)(config-dhcpv6)#preference <value>
To enable DHCPv6 Server functionality on an interface, use the following command:
(host) (config) #interface vlan <vlan-id>
(host) (config-subif) #ipv6 dhcp server <pool-name>
The configured DHCPv6 pool subnet must match the interface prefix for DHCPv6 Server to be active.
To configure the IPv6 excluded address range for the DHCPv6 server, use the following command:
(host)(config)#ipv6 dhcp excluded-address <low-address> [<high-address>]
You can view the DHCPv6 server settings, statistics, and binding information using the CLI.
To view the DHCPv6 database, use the following command:
(host)#show ipv6 dhcp database
You can also view the DHCPv6 database for a specific pool, use the following command:
(host) (config) #show ipv6 dhcp database [pool <pool-name>]
(host) (config) #show ipv6 dhcp database pool DHCPv6
To view the DHCPv6 binding information, use the following command:
(host)# show ipv6 dhcp binding
To clear all the DHCPv6 bindings, use the following command:
(host)# clear ipv6 dhcp binding
To view the DHCPv6 server statistics, use the following command:
(host)(config) #show ip dhcp statistics
To view the DHCPv6 active pools, use the following command:
(host) #show ipv6 dhcp active-pools
Understanding AOS-W Supported Network Configuration for IPv6
Clients
AOS-W provides wired or wireless clients using IPv6 addresses with services such as firewall functionality, layer-
2 authentication, and, with the installation of the Policy Enforcement Firewall Next Generation (PEFNG),
identity-based security. The Alcatel-Lucent switch does not provide routing or Network Address Translation to
IPv6 clients (see Understanding IPv6 Exceptions and Best Practices on page 155).
Supported Network Configuration
Clients can be wired or wireless and use IPv4 and/or IPv6 addresses. An external IPv6 router is recommended
for a complete routing experience (dynamic routing). You can use the WebUI or CLI to display IPv6 client
information.
On the switch, you can configure both IPv4 and IPv6 client addresses on the same VLAN.
AOS-W 6.5.3.x | User Guide IPv6 Support | 148