668| IP Mobility AOS-W 6.5.3.x| User Guide
In the CLI
On switch A (the master switch):
(host)(config) #router mobile
(host)(config) #ip mobile domain default
(host)(mobility-domain) #hat 10.1.1.245 description "Corporate mobile entry"
(host)(mobility-domain) #hat 10.2.1.245 description "Local entry"
(host)(mobility-domain) #hat 10.3.1.245 description "Reserved reentry"
(host)(mobility-domain) #hat 10.4.1.245 description "Sales team"
(host)(mobility-domain) #!
(host)(config)# ip mobile active-domain default
On switches B and C:
(host)(config) #router mobile
(host)(config)# ip mobile active-domain default
Tracking Mobile Users
This section describes how you can view information about the status of mobile clients in the mobility domain.
Location-related information for users, such as roaming status, AP name, ESSID, BSSID, and physical type are
consistent in both the home agent and foreign agent. The username, role, and authentication can be different
on the home agent and foreign agent, as explained by the following:
Starting with AOS-W 6.3, L2 GRE tunnels are automatically established between switches in mobility domain at
the time of boot up. Before AOS-W 6.3, the tunnels were created only when a client was associated to a switch.
Whenever a client connects to a switch in a mobility domain, layer-2 authentication is performed and the
station obtains the layer-2 (logon) role. When the client roams to other networks, layer-2 authentication is
performed and the client obtains the layer-2 role. If layer-3 authentication is required, this authentication is
performed on the client’s home agent only. The home agent obtains a new role for the client after layer-3
authentication; this new role appears in the user status on the home agent only. Even if reauthentication
occurs after the station moves to a foreign agent, the display on the foreign agent still shows the layer-2 role
for the user.
Mobile Client Roaming Status
You can view the list of mobile clients and their roaming status on any switch in the mobility domain:
In the WebUI
Navigate to the Monitoring > switch > Clients page.
In the CLI
#show ip mobile host
Roaming status can be one of the following:
To Next Page
Loading...