Alcatel-Lucent AOS-W 6.5.3.x - Connecting to an Omnivista Server

842| Management Access AOS-W 6.5.3.x| User Guide
In the CLI
To define a timeout interval for a CLI session, use the command:
(host)(config) #loginsession timeout <value>
In the above command, <val> can be any number of minutes from 5 to 60 or seconds from 1 to 3600,
inclusive. You can also specify a timeout value of 0 to disable CLI session timeouts.
Connecting to an OmniVista Server
OmniVista is a powerful and easy-to-use network operations system that manages Alcatel-Lucentwireless,
wired and remote access networks, as well as wireless and wired infrastructures from and a wide range of third-
party manufacturers.
Switches running AOS-W 6.3 and later can use the OmniVista wizard in the Configuration > Wizards >
OmniVista section of the switch WebUI to quickly and easily connect the switch to an OmniVista server. The
following checklist lists the information you will need to use this wizard. Determine each of these values for
your deployment and OmniVista server before you start the wizard process.
Information Description My Values
OmniVista
IPaddress
IP address of the OmniVista server.
SNMP version
Specify if the switch and OmniVista serer should communicate using
SNMP v2 or SNMPv3. SNMPv3 communications between a switch
and an OmniVista server use SHAauthentication and AES encryp-
tion.
For SNMPv2
If you select SNMPv2, you must enter an SNMP community string.
Table 187: OmniVista Wizard Checklist