Alcatel-Lucent AOS-W 6.5.3.x - Configuring ANQP Roaming Consortium Profiles; Configuring ANQP 3 GPP Cellular Network Profiles

909| 802.11u Hotspots AOS-W 6.5.3.x| User Guide
Configuring ANQP Roaming Consortium Profiles
Organization Identifiers (OIs) are assigned to service providers when they register with the IEEE registration
authority. You can specify the OI for the hotspot’s service provider in the ANQP Roaming Consortium profile
using the ANQP Roaming Consortium Profile. The Hotspot 2.0 profile also allows you to define and send up to
three additional roaming consortium OIs for the service provider’s top three roaming partners.
To send the values configured in this profile to clients, you must associate this profile with an advertisement
profile, then associate the advertisement profile with a hotspot 2.0 profile. For details, see Configuring Hotspot
Advertisement Profiles on page 899.
In the WebUI
To configure an ANQP roaming consortium profile from the switch WebUI:
1. Navigate to Configuration>Advanced Services>All Profiles.
2. In the profiles list, expand the Wireless LAN section.
3. Select ANQP Roaming Consortium.
4. Select an existing profile from the list of profiles on the profile details pane or create a new profile by
entering a profile name into the entry blank, then clicking Add.
5. Configure the following parameters as desired, then click Apply to save your settings.
Parameter Description
Roaming consortium OI
Len
Length of the OI. The value of the Roaming consortium OI Len parameter must
equal upon the number of octets of the Roaming Consortium OI field.
n 0: 0 Octets in the OI (Null)
n 3: OI length is 24-bit (3 Octets)
n 5: OI length is 36-bit (5 Octets)
Table 214: ANQP Roaming Consortium Profile Parameters
In the CLI
To configure an ANQP roaming consortium profile from the switch CLI, access the CLI in config mode and issue
the following commands:
wlan hotspot anqp-roam-cons-profile <profile-name>
clone <profile-name>
no ...
roam-cons-oi <roam-cons-oi>
Configuring ANQP 3GPP Cellular Network Profiles
Use this profile to define priority information for a 3rd Generation Partnership Project (3GPP) Cellular Network
used by hotspots that have roaming relationships with cellular operators.
To send the values configured in this profile to clients, you must associate this profile with an advertisement
profile, then associate the advertisement profile with a hotspot 2.0 profile. For details, see Configuring Hotspot
Advertisement Profiles on page 899.
In the WebUI
To configure an ANQP 3GPP cellular network profile from the switch WebUI: