Alcatel-Lucent AOS-W 6.5.3.x - Page 908

Parameter Description
NAI Realm Authentication 1
NAI Realm Authentication 2
Use the NAI Realm Authentication 1 and NAI Realm Authentication
2 parameters to send the one of the following authentication methods for
the primary NAI realm ID.
Supported authentication methods:
n credential-type: The specified authentication ID uses credential
authentication.
n expanded-eap: The specified authentication ID uses the expanded EAP
authentication method.
n expanded-inner-eap: The specified authentication ID uses the
expanded inner EAP authentication method.
n inner-auth-eap: The specified authentication ID uses inner EAP
authentication type.
n non-eap-inner-auth: The specified authentication ID uses non-EAP
inner authentication type.
Supported authentication values:
n cred-cert: Credential - Certificate
n cred-hw-token: Credential - Hardware Token
n cred-nfc: Credential - NFC
n cred-none: Credential - None
n cred-rsvd: Credential - Reserved
n cred-sim: Credential - SIM
n cred-soft-token: Credential - Soft Token
n cred-user-pass: Credential - Username/password
n cred-usim: Credential - USIM
n cred-vendor-spec: Credential - Vendor-specific
n eap-crypto-card: EAP Method - Crypto-card
n eap-generic-token-card: EAP Method - Generic-Token-Card
n eap-identity: EAP Method - Identity
n eap-method-aka: EAP Method - AKA
n eap-method-sim: EAP Method - SIM - GSM Subscriber Iden
n eap-method-tls: EAP Method - TLS - Transport Layer Sec
n eap-method-ttls: EAP Method - TTLS - Tunneled Transport Security
n eap-notification: EAP Method - Notification
n eap-one-time-password: EAP Method - One-Time-Password
n eap-peap: EAP Method - PEAP
n eap-peap-mschapv2: EAP Method - PEAP MSCHAP V2
n non-eap-chap: Non-EAP Method - CHAP
n non-eap-mschap: Non-EAP Method - MSCHAP
n non-eap-mschapv2: Non-EAP Method - MSCHAPv2
n non-eap-pap: Non-EAP Method - PAP
n non-eap-rsvd: Non-EAP Method - Reserved for future use
n reserved: Reserved for Future use
NAI Home Realm Mark the realm in this profile as the NAI Home Realm
In the CLI
The following example configures two ANQP NAI realm profiles from the switch CLI
wlan hotspot anqp-nai-realm-profile home
enable
nai-realm-name corp-hotspot.com
nai-realm-auth-param-1 id credential-type value cred-cert
nai-home-realm
!
wlan hotspot anqp-nai-realm-profile non-home
nai-realm-name corp-hotspot-roam.com
nai-realm-eap-method eap-sim
nai-realm-auth credential-type
AOS-W 6.5.3.x | User Guide 802.11u Hotspots | 908