Alcatel-Lucent AOS-W 6.5.3.x - Deploying a Branch;Home Office Solution

3. Select the AP profile for which the secondary master switch feature is to be enabled. The Profile Details
section is displayed.
4. Navigate to the Basic > General tab.
5. Enter an IP or FQDN value for the secondary master switch in the Secondary Master IP/FQDN field.
Figure 99 Profile Details
In the CLI
Execute the following command to enable the secondary master switch feature.
(host) (config) #ap system-profile <profile name>
(host) (AP system profile "profile name")#secondary-master <value>
Deploying a Branch/Home Office Solution
In a branch office, the AP is deployed in a separate IP network from the corporate network. Typically, there are
one or two NAT devices between the two networks. Branch office users need access to corporate resources
such as printers and servers, but traffic to and from these resources must not impact the corporate head
office.
Figure 100 is a graphic representation of a remote AP in a branch or home office, with a single switch providing
access to both a corporate WLAN and a branch office WLAN.
AOS-W 6.5.3.x | User Guide Remote Access Points | 703