836| Management Access AOS-W 6.5.3.x| User Guide
n Absolute Session Timeout: This setting specifies the absolute time after which the WebUI session times
out post a successful authentication.
You can configure these settings from either the switch WebUI or CLI.
In the WebUI
To configure the WebUI session timer using the WebUI, follow the procedure below.
1. Navigate to the Configuration > Management > General page.
2. Under WebUI Session Timer, configure the settings described in Table 186.
Parameter Description
Idle session timeout This setting specifies the time of inactivity after which the WebUI session times out and
requires login for continued access.
Default: 900 seconds
Range: 30-3600 seconds
Absolute session
timeout
This setting specifies the absolute time after which the WebUI session times out post a
successful authentication.
Default: Disabled
Range: 30-3600 seconds
Table 186: WebUI Session Timer Settings
In the CLI
To configure the WebUI session timer using the CLI, execute the following commands.
(host) (config) #web-server profile
(host) (Web Server Configuration) #session-timeout 900
(host) (Web Server Configuration) #absolute-session-timeout 300
To view the configuration using the CLI, execute the following command.
(host) #show web-server profile
Web Server Configuration
------------------------
Parameter Value
--------- -----
Cipher Suite Strength medium
SSL/TLS Protocol Config tlsv1 tlsv1.1 tlsv1.2
Switch Certificate default
Captive Portal Certificate default
IDP Certificate default
Management user's WebUI access method username/password
User absolute session timeout <30-3600> (seconds) 300
User session timeout <30-3600> (seconds) 900
Maximum supported concurrent clients <25-320> 75
Enable WebUI access on HTTPS port (443) false
Web Skype4B Listen Protocol/Port Config N/A
Enable bypass captive portal landing page true
Enabling RADIUS Server Authentication
This section include many different types of RADIUS server configuration and related procedures.
To Next Page
Loading...