740| Remote Access Points AOS-W 6.5.3.x| User Guide
Figure 111 Provision using a USB Modem with Custom Settings
n Device Type
n Initializing String
n PPP Username
n PPP Password
n TTY Device Path
n Device Identifier
n Dial String
n Link Priority Cellular—This is a number that identifies the priority of the connection. If the Link Priority
Cellular has a higher number than Link Priority Ethernet, then cellular connection is used.
n Link Priority Ethernet—This is a number that identifies the priority of the connection. If the Link Priority
Ethernet has a higher number than Link Priority Cellular, then Ethernet connection is used.
3. Click Save after you have entered all the details and click Continue to complete provisioning of your RAP.
Configuring OAW-RAP3WN and OAW-RAP3WNP Access Points
The Alcatel-LucentOAW-RAP3WN and OAW-RAP3WNP are single-radio, single-band wireless APs that support
the IEEE 802.11n standard for high-performance WLAN. These APs use MIMO (Multiple-In, Multiple-Out)
technology and other high-throughput mode techniques to deliver high-performance, 802.11n 2.4 GHz
functionality while simultaneously supporting existing 802.11 b/g wireless services.
See the Alcatel-Lucent OAW-RAP3WN Installation Guide for more information.
These access points require Alcatel-Lucent Instant 3.0 or later to operate as an Instant AP, or AOS-W 6.1.4.0 or later
to operate as a Remote AP.
The Power Sourcing Equipment (PSE) functionality is available only for OAW-RAP3WNP APs, as the PoE itself
provides the PSE functionality for OAW-RAP3WN APs. You can use the WebUI or CLI to enable or disable the
PSE functionality on the OAW-RAP3WNP APs.
To Next Page
Loading...