Alcatel-Lucent AOS-W 6.5.3.x - Configuring OSPF

O 14.1.1.0/24 [1/0] via 5.1.1.1
O 15.1.1.0/24 [1/0] via 5.1.1.1
C 5.1.1.0 is directly connected, VLAN5
Configuring OSPF
To configure general OSPF settings from the OSPF tab, perform the following steps:
1. Navigate to the Configuration >IP page (see Figure 31). The Area and Excluded subnets are displayed in
table format. If not explicitly specified for OSPF, the router ID defaults to the switch IP.
Figure 31 General OSPF Configuration
2. Click Add to add an area (see Figure 32).
Figure 32 Add an OSPF Area
3. Configure the OSPF interface settings in the Configuration screen (Figure 33). If OSPF is enabled, the
parameters contain the correct default values. You can edit the OSPF values only when you enable OSPF on
the interface.
AOS-W 6.5.3.x | User Guide OSPFv2 | 165