905| 802.11u Hotspots AOS-W 6.5.3.x| User Guide
In the CLI
To configure an ANQP domain name profile from the switch CLI, access the CLI in config mode and issue the
following commands:
wlan hotspot anqp-domain-name-profile <profile-name>
domain-name <domain-name>
no ...
Configuring ANQP IPAddress Availability Profiles
Use this profile to specify the types of IPv4 and IPv6 IP addresses available in the hotspot network. This
information is sent in an Access network Query Protocol (ANQP) information element in a Generic
Advertisement Service (GAS) query response.
To send the values configured in this profile to clients, you must associate this profile with an advertisement
profile, then associate the advertisement profile with a hotspot 2.0 profile. For details, see Configuring Hotspot
Advertisement Profiles on page 899.
In the WebUI
To configure an ANQP IPaddress availability profile from the switch WebUI:
1. Navigate to Configuration>Advanced Services>All Profiles.
2. In the profiles list, expand the Wireless LAN section.
3. Select ANQP IPAddress Availability
4. Select an existing profile from the list of profiles on the profile details pane or create a new profile by
entering a profile name into the entry blank, then clicking Add.
5. Configure the following parameters as desired, then click Apply to save your settings.
To Next Page
Loading...