Alcatel-Lucent AOS-W 6.5.3.x - Configuring ANQP Venue Name Profiles

901| 802.11u Hotspots AOS-W 6.5.3.x| User Guide
In the CLI
To configure a advertisement profile from the switch CLI, access the CLI in config mode and issue the following
commands:
wlan hotspot advertisement profile <profile-name>
anqp-3gpp-nwk-profile <profile-name>
anqp-domain-name-profile <profile-name>
anqp-ip-addr-avail-profile <profile-name>
anqp-nai-realm-profile <profile-name>
anqp-nwk-auth-profile <profile-name>
anqp-roam-cons-profile <profile-name>
anqp-venue-name-profile <profile-name>
clone <profile-name>
h2qp-conn-cap-profile <profile-name>
h2qp-op-cl-profile <profile-name>
h2qp-operator-friendly-profile <profile-name>
h2qp-osu-prov-list-profile <profile-name>
h2qp-wan-metrics-profile <profile-name>
no ...
osu-ssid <osu-ssid>
Associating the Advertisement Profile to a Hotspot 2.0 Profile
The settings in the ANQP and H2QP profiles referenced by the Advertisement profile will not be sent to clients
until you associate the advertisement profile with an active hotspot 2.0 profile. By default, all hotspot 2.0
profiles reference the default advertisement profile.
In the WebUI
To associate a different advertisement profile to a hotspot 2.0 profile:
1. Navigate to Configuration>Advanced Services>All Profiles.
2. In the Profiles list, click Wireless LAN expand the Wireless LAN profiles section.
3. Select Hotspot 2.0. The list of available hotspot 2.0 profiles appears in the Profiles list.
4. In the Profiles list, select a hotspot 2.0 profile.
5. Click the Advertisement link that appears below the selected hotspot 2.0 profile.
6. In the Profile Details list, click the Advertisement Profile drop-down list and select a different
advertisement profile name.
7. Click Apply.
In the CLI
To associate a different advertisement profile to a hotspot 2.0 profile from the switch CLI, access the CLI in
config mode and issue the following commands:
wlan hotspot hs2-profile <hotspot-profile-name>
advertisement-profile <advertisement-profile-name>
Configuring ANQP Venue Name Profiles
Use this profile to define the venue group and venue type information be sent in an Access network Query
Protocol (ANQP) information element in a Generic Advertisement Service (GAS) query response. If a client uses
the Generic Advertisement Service (GAS) to post an ANQP query to an Access Point, the AP will return ANQP
Information Elements with the values configured in this profile.